Vauxhall ZAFIRA Owner's Manual page 225

Vehicles with jack shown in figure 12548 T:
Ad just jack to required height by hand
before p ositioning. Position arm of jack
at front and rear such that jack cla w
surrounds the vertica l ridge and engages
in the recess in the ridge.
The base of the jack m ust be directly
below the jacking point with good
contact to the floor. I f this is not the ca se
during jac king , carefully low er the
vehicle and rep osition the jack.
Attach crank to eye of thread ed rod and
turn crank to ra ise vehicle.
5. Unscrew w heel bolts and store them
where the threads will not be soiled.
6. C hange wheel. For notes on spare w heel
and temporary spare wheel
- see pag e 218.
7. Sc rew wheel bolts in and tighten slightly.
8. Lower v ehicle.
9. Tighten wheel b olts in criss-cross
sequenc e.
10. Align and refit w heel cov er 3 or wheel
bolt caps 3 .
Before refitting the wheel cov er, c lean
the w heel a round the retaining clips.
Valve symb ol 3 on bac k of w heel cover
must point tow ards valve on wheel.
Alloy wheels 3: Press on and engage
hub cap, inserting p in on b ack of hub
cap into corresponding hole in w heel.
Alloy wheels with anti-theft lock 3:
Align hub cap. Insert and tighten
anti-theft lock 3 .
11. Store away replaced wheel, tools and
warning triangle 3 in lug gage
compartment – see pag e 218.
12. Have the tightening torque of the wheel
bolts on the new wheel checked on the
vehicle and c orrected if necessary. For
tightening torque - see p age 270.
13. Replace changed, defective tyre with a
new one.
223