KitchenAid Architect K6CP462K Installation Instructions Manual page 5

Gas and Electric
Dimensions
3-prong ground-type outlet
shouldbelocated onleft hand
side ofcutout 8 " 20.3 cm)
max. from eflc
osure s dewa .
Gas supply lineshould he
located inthis areaonrearor
side walls, o r thesupply l ine can
come upthrough thefloor.
Gas and Electric
Connection Locations
product r ating/serialtag
controlsup_r_ panel
Note: Solid side and
bottom of cutout
enclosure net shown,
Gas supply
requirements
Explosion Hazard
Use a new AGA or CSA approved
gas supply line.
Install a shut-off valve.
Securely tighten all gas
connections.
If connected to LP, have a
qualified person make sure gas
pressure does not exceed 14"
water column.
Examples of a qualified person
include licensed heating
personnel, authorized gas
company personnel, and
authorized service personnel.
Failure to do so can result in
death, explosion, or fire.
Observe all governing codes and
ordinances.
important: Cooktop must be connected to
a regulated gas supply.
regulator (
with product) must he
installed with arrow up
pointing at ¢ooktop
bonom
1/2" nipple
(not supplied)
AGAor CSA approved
flexible stainless
steel gas supply line
(not supplied)
shut off valve
(not supplied)
36" (91.4 cm)
3-prong ground-type
power supply cord
\
regulated gas
supply line
Typical Gas and Electric
Connections
Copies of the standards listed may be
obtained from:
* CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio 44131-5575
A= This installation must conform with
local codes and ordinances, in the
absence of local codes, installations must
conform with American National
Standard, National Fuel Gas Code
ANSI Z223.1 -- latest edition or
CANI -- B149.1 or 2*.
[] Input ratings shown on the
model/serial rating plate are for elevations
up to 2,000 feet (610 m). For elevations
above 2,000 feet (610 m), ratings are
reduced at a rate of 4% for each 1,000
feet (305 m) above sea level.
C gThe cooktop is equipped for use
with NATURAL gas. it is design-certified
by International Approval Services (I.A.S.)
for NATURAL and L.R gases with
appropriate conversion. The model/serial
rating plate, located on the underside of
the burner box, has information on the
type of gas that can be used. If this
information does not agree with the type
of gas available, check with the local gas
supplier.
5