Advertisement
SingUeoven
DoubUe oven
28o3/8"
(72,1 ore} reax_
recessed
49-I/2"
{12&7 ore)
recessed
height
23"
(58,4 ore)
reax.
recessed
depth
7
27-3/4"
{7&5 ore)
rein,
cutout
height
2_
"_------30"(7&2
cre) rein,_
cab net wdth
28=1/2"
{72,4 ore)
cutout
width
Singmeoven
undercounter
{without cooktop
installed above)
1-1/2"
(3.8 crel rein,
top of cutout
to underside
of countertop
49-3/4"
(126,4 ore)
rein,
cutout
height
5ol/4" {13.3 ere)
bottom of cutout
to floor
1=1/2" (&8 ore}
rein_ bottom
of
cutout
to top of
cabinet
door
3e" (7&2 crel
min, cabinet
28=1/2"
_{72,4
cre)_
cutout
width
cabinet_-_-
23=1/4"
(59,1 crel rein,
cutout
depth
23" (58.4 ore)
_---recessed
oven_
depth
J
recessed
oven
_
oven
front
Cabinet side view
Cabinet filler kits are available from your dealer.
Use a matching color kit if oven is smaller than
your cabinet opening.
Single oven filler height is 3o5/16" (8.4 cm)
Black
-- 4378941
White
-- 4378942
Almond-
4378943
Double oven filler height is 6o5/16" (16 cm)
Black
-- 4378947
White
-- 4378948
Almond-
4378949
27=3/4"
{7&5 ore}
rein,
cutout
height
1=1/2"
(3,8 ere)
rein,
bottom
of
cutout
to
top of
cabinet
door
Doubmeoven
30" (76.2 ore} rein,
cabinet width
28=1/2"
_----{72,4
cre}------:b,
cutout
width
Singmeoven
.j-
5I"
{12e.5 ore)
reS)L
overall
height
i
1" (2,5 ore} top
of cutout
to
bottom
of upper
cabinet
door
14=3/4"
{37.5 ore)
bottom
of cutout
to floor
1" (2,5 ore} top
of cutout
to
bottom
of upper
cabinet
door
32"
{813 ore)
bottom of
cutout
to
floor
Year safety aRd the safety of ethers are
very important.
We have provided many important safety
messages in this manual and on your appliance.
Always read and obey alI safety messages.
This is the safety alert symbol.
This symbol alerts you to potential
hazardsthat can kill or hurt you and
others.
AIi safety messageswiii foiiow the safety alert
symbol and either the word "DANGER"or
"WARNING"= These words mean:
You can be killed or seriously injured if you
don't fellow instructions.
AtI safety' messageswilI tetI you what the
potentiai hazard is, teii you how to reducethe
chance of injury, and teli you what can happen if
the instructions are not followed.
important: Observe all governing
codes
and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this even.
Oven location should be away from strong
draft areas, such as windows, doors and
strong heating vents.
Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed
portion of the oven.
ElectricaJ ground is required. See "Electrical
requirements."
Electrical suppJy junction box should be
located 3 inches (7.6 cm} maximum below the
support surface when oven is installed in a
wall cabinet. Drill a 1-inch minimum (2.5 cm}
diameter hole in the right rear or left rear
corner of the support surface to pass the
appliance cable through to the junction box.
For undercounter installation, it is
recommended that the junction box be
located in the adjacent right or left cabinet. If
installing the junction box on rear wall behind
oven, junction box must be recessed and
located in the upper or lower right or left
corner of cabinet.
It is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANa{/NFPA 70 E latest
latest edition*, or Canadian L=lectdcal Code,
C22.1-1982 and C22.2 No. 01982 (or latest
edition)** and all local codes and
ordinances.
Copies of the standards
listed may be obtained
from:
* National
Fire Protection
Association
Batteryreamh
Park
Quincy,
Massachusetts
02289
_ CSA International
8501 East Pleasant
Valley
Road
Cleveland,
Ohio 44131-5575
Tool
_/
PhimHps
screwdriver
Parts supplied:
4 screws (double
oven)
Page 1
Advertisement
