Advertisement
7=
Align support mounting
bracket
with holes in ceiling. Attach support
system frame
to ceiling using anchors
recommended
for your
type of ceiling:
• Concrete ceiling -- use inserts and
screws provided.
• Wood ceiling -- use 4" (10.2 cm)
long wood screws.
• Plaster or sheet rock ceiling --
attach support
mounting
bracket
to ceiling joists if possible,
If
ceiling joists ere not available,
you
must
build a supporting
structure
behind
the plaster
or sheet rock.
Make sure the support
is connected
firmly to ceiling.
,= Determine
the height of the
canopy,
The range hood requires
at
least 24" (6! cm) of clearance
between
bottom
of range hood
canopy
and
cooking
surface.
The bottom
of the canopy will be
approximately
9" (22.9 cm) below the
bottom of the support
system.
To
change
the canopy height° loosen
the
four set screws on the support frame.
Adjust
support frame to the desired
length
and tighten a11four set Screws
firmly in place before attaching
canopy.
If used, attach the vent damper
to the
inside bottom of the chimney
support
frame.
Make sure damper
opens to
outside.
= Press on handle in front of
filters to release filters from range
hood canopy. Remove filters and set
aside.
1 O.
,emove
the terminal
box
cover from
the range hood.
Remove
the power supply
cable knockout
using a flat-blade
screwdriver.
Do not
remove optional
remote blower
knockout.
Attach conduit connector
into power supply cable opening
so
that conduit connector clamping
screws are inside the terminal
box.
Excessive Weight Hazard
Use two or more people 1omove
and install island canopy hood.
Failure to do so can result In back
or other injury.
slot
1/4"
(6.4 ram)
1.
Loosen four bolts located
next to exhaust opening so that there
is approximately 1/4" (6.4 ram) space
between bolt head and canopy. Lift
canopy and insert bobs into slots in
support system frame, lighten
bolts
to support system frame and canoby.
Electrical
connection
Electrical
Shock Hazard
Disconnect
power before
making electrical connections.
Connect ground wire to green
ground screw in terminal box.
Failure to do so can result in
death or electrical shock.
2
• Make electrical connection:
[]
Disconnect
power
supply.
[]
Feed enough power supply cabJe
through
conduit
connector _o
make electrical
connections,
[]
Connect
the power
supply cable to
hood terminal
box through
the
U.L-
or C.S.A.-listed
conduit
connector.
[]
Connect the white wire of the
power
supply cable with the white
lead in the hood
using a twist-on
connector;
connect the black wire
of the power supply cable with the
black lead in the hood using a
twist-on
connector.
[]
Connect the power supply green
(green and yellow) ground wire
under the green, ground screw.
[]
"tighten conduit connector
screws.
[]
Replace the terminal
box cover.
Advertisement
