ezee TORQ MK II User Manual page 9

Torq
Tools required
you will need a
Allen / Hex key metric set
Philips head screwdriver
Open-end flat wrenches metric
measurements 6mm - 17mm
Front wheel
ensuring that it is properly seated in the dropout slots. Tighten the
nuts alternatively on both sides till the wheel is secured.
Tightening torque
Seat post
and align. Tighten clamps and ensure seat is firmly fastened.
Tigtening torque
6
Do not adjust the seat post beyond its maximum extension
mark.
Headstem
perpendicular to the frame before tightening as shown below.
Tools are the first step to proper assembly,
Insert the hub motor wheel into the front fork,
35 Nm
Insert into the seat tube of the bicycle frame
16 Nm
Align headstem and handlebar so that it is
Assembly
9