ezee TORQ MK II User Manual page 22

No. of Explanation
blinks
8 Hall sensor in motor
faulty
9 Supply 3 phase wire
10 Controller overheating
11 Thermostat faulty
12 Controller failure
2+3 Controller failure
3+4 Stalled motor
3+5 Supply 3 phase wires
No Light Power supply faulty /
Controller failure
The faults listed may not cover every possible failure. In the
event of moisture or water entering the controller, haphazard
signals might appear. We've designed the eZeebike to repel water
as much as possible, encapsulating circuit boards with silicone
resins and connections with silicone grease.
Since this manual simply cannot cover every detail that
might occur during the lifetime of your product. Check our websites
and dealers website routinely for updates, or contact us directly for
more detailed questions you might have.
22
Troubleshooting
Solution
One or more hall sensor disconnected or faulty.
Check connector at the front fork. If connector
is OK, contact your eZee dealer
Check phase wires at the front fork. Contact your
eZee dealer
Motor continue to function but the amps directed
will be lessened to reduce the load and cool
controller
the motor will continue to work, but extreme
temp. arise without thermostat protection may
damage controller - Replace controller
Motor does not work - Replace controller
Motor does not work - Replace controller
Extremely overload stalling motor, switch off and
on – reboot
Inspect cable and connector for dislocation or
damage. Diagnostic appears during throttle us-
age.
Inspect battery and power connections for dam-
age / Replace controller