Clarion NX702E Owner's Manual page 15

Setup
Touch [Setup] on the right of screen to
spread the setting list. then touch the button
to the right of desired option to adjust or
show the sub-menu. Touch [Close] to close
the list.
AUX
• Input Aux Sense
Choose "Low", "Middle" or "High" input
sense of auxiliary device.
Bluetooth
• Bluetooth
Choose Bluetooth function on or off.
• Telephone Speaker
Choose Front Left or Front Right speaker
at telephone mode.
• Tone Select
Touch [Auto] to use ringtones of your
mobile phone.
Touch [Internal] to use preset ringtone of
the unit.
• Software Update
Update the software.
Camera
• Camera Interrupt
Choose [On], the screen will switch to rear
camera menu automatically when backing.
DVD
• Menu Language
Select menu language from list.
• Audio Language
Select audio language from list.
• Subtitle Language
Select subtitle language from list.
• Set Password
To set password for parental control,
Touch [Set] to show password menu.
Input numbers by touching the digit and
[OK] buttons. Touch [X] button to delete a
digit inputted. Touch [Back] to exit.
14
NX702E
• Parental Control
Touch the button to the right of "Parental
Control" to show parental control menu.
Enter password, then select a parental
level. Touch [OK] to confirm or [Back] to
exit.
Navigation
• Navigation Interrupt
Select navigation interrupt On, Pop-Up or
Off.
• Voice Guidance
ON: Interrupt function of voice guidance
is on. While interrupting no attenuate
function of AV sound.
MUTE: Interrupt function of voice guidance
is on. While interrupting attenuate function
of AV sound is on.
OFF: Interrupt function of voice guidance
is off. While interrupting no attenuate
function of AV sound.
Anti Theft
• Anti Theft code
You can set an Anti-theft code. After set
successfully, when Battery wire reconnect,
you need to input the Anti-theft code.
1. Long press the [General] button until a
dialog box popped up. Touch [Yes] to set
a personal code of Anti-Theft.
2. Input a 4-digit code. Touch [OK] to confirm.
Then input it again for confirmation.
3. To remove the code, long press the
[ G e n e r a l ] b u t t o n a n d i n p u t t h e o l d
password.
Note:
Please make a note of the Anti theft code not
to forget. if the right code is not inputted, it
becomes impossible to operate this unit.