Table of Contents
Advertisement
KORG D16 Guide
Continue working with the Scrub function in Loop Playback mode:
1. Press the PLAY key, watch the waveform display, and listen: Track 6 plays from the IN point at normal
speed for two seconds, then automatically stops (because the Scrub function is on).
2. Now hold the STOP key and press the PLAY key. The audio data will play at normal speed, from two
seconds before the registered IN point, and then playback will stop.
3. Press to highlight the Out: 000.000.000 time in the display, and rotate the DIAL to scrub the audio, until
the Out: time reaches approximately 003.01.087. If you go past this Out time, rotate the DIAL to the left.
4. Press the PLAY key. The audio data will play from that point at normal speed, for two seconds, then
stop.
5. Hold the STOP key and press the PLAY key. The audio data will play at normal speed, from two
seconds before the OUT point and then stop.
6. Press the OK button in the display, and note the registered IN and OUT time in the display.
7. Press the Loop:Off button in the display, and the LOOP key will light.
8. Press the PLAY key. Now the registered time will loop repeatedly.
9. After you've listened to the loop, press the STOP key, then press the Loop:On button in the display to
exit Loop Playback mode.
Tip: By using the WAVE and SCRUB functions, you can be more precise in locating IN and OUT points to
set for Loop Playback (and Loop Recording). You can register IN and OUT Points while the D16 is stopped
or during playback, first by using the STORE and IN / OUT keys, and then by "fine-tuning" the loop points
with the WAVE and SCRUB functions.
Set IN and OUT points while the song plays back:
1. Press the SONG key, then locate to measure 001.01.000, by holding the STOP key and pressing the
REW key once).
2. Press the PLAY key, and listen to the song to get a feel for the rhythm. While the song plays, press the
STORE key, followed by pressing the IN / LOC1 key, to store an IN point wherever you like.
3. Continue to let the song play, and in that same "perfect tempo you were born with", press the STORE
key, followed by pressing the OUT / LOC2 key, to store the OUT point wherever you like.
4. Press the STOP key, then press the LOOP key.
5. Press the Loop:Off button in the display, and the LOOP key will light.
6. Press the PLAY key and the registered IN and OUT time will loop repeatedly.
7. Press the STOP key, then press the Loop:On button in the display to turn off Loop Playback.
38
Advertisement
Table of Contents
