Table of Contents
Advertisement
Available languages
Available languages
840112800ENv03.qxd 3/27/03 2:46 PM Page 6
Placement of the Cooler/Warmer
• To ensure proper performance, maintain
at least 4 inches of air space around the
cooler/warmer. Do NOT block or cover
the exterior vents.
• Do not place objects on top of unit.
• Do not place unit where it will be
subjected to high temperatures,
moisture, or direct sunlight.
• Do not place unit on wood or other
surfaces that could be damaged by
moisture or condensation.
AC
(Indoor) Operation
1. Make sure the switch is set to OFF.
2. Plug the AC/DC converter (home) into
the DC jack on the back of the unit.
3. Plug the other end of the cord into a
standard 120V wall outlet.
4. Select the desired mode by sliding the
switch to WARM or COOL.
5. Turn the unit OFF before unplugging
the cord.
DC
(Car) Operation
1. Make sure the switch is set to OFF.
2. Plug the DC power cord (car) into the DC jack on the back of
the unit.
3. Plug the other end of the cord into a 12V DC cigarette lighter or
accessory jack.
4"
4"
O
HOT
COLD
6
4. Select the desired mode by sliding the
switch to WARM or COOL.
5. Turn the unit OFF before unplugging the
cord or when the vehicle is turned off.
Leaving the unit running in a car that is
turned off for an extended period of
time will drain the car's battery.
6. Secure unit to ensure that it does not
become a hazard in the event of a
sudden stop or while turning.
Important: Do not leave unit unattended.
On a typical 95°F day, the interior temperature of a car can reach
140°F within 45 minutes. Extreme temperatures can damage your
unit and affect the performance.
Replacing the Fuse in the DC Power Cable
Replace the fuse with an AGC 6 Amp automotive fuse only.
Use only the 12V DC power cord supplied with the appliance.
1. Unplug cord from the unit.
2. Unplug 12V DC power cord from 12V DC
cigarette lighter or accessory jack.
3. To replace the glass fuse in the DC
cigarette lighter plug, unscrew the plug
tip and set it aside.
4. Remove the old glass fuse and insert a
new AGC 6A automotive fuse.
5. Screw the plug tip onto plug.
6. Insert the plug into the unit.
7. Insert the plug into the 12V DC cigarette lighter or accessory jack.
O
HOT
COLD
6A fuse
Plug tip
7
Advertisement
Table of Contents
