Connecting To A Power Supply - Hitachi CP-AW2519N Manual

Setting up

Connecting to a power supply

Put the connector of the power cord into the
1.
AC IN (AC inlet) of the projector.
Firmly plug the power cord's plug into the
2.
outlet. In a couple of seconds after the
power supply connection, the POWER
indicator will light up in steady orange.
Please remember that when the DIRECT
POWER ON function activated (
connection of the power supply make the
projector turn on.
Make sure that the cover is not attached to
3.
the pen sensor when the interactive pen is
used.
WARNING
incorrect or faulty connections may result in fire and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fire, electric shock
or other accidents.
• Keep the sensor cover away from children and pets. Be careful so that they do
not put it into their mouth.
NOTICE ►Please ensure that dust is not adhered to the pen sensor as it will
deteriorate the performance of the sensor. With the exception of installing the
projector in high places, you can use the sensor cover provided to keep the pen
sensor from getting dusty when it is not in use. Take care not to lose the cover
for the pen sensor when it is not in use.
14
►Please use extra caution when connecting the power cord, as
56), the Power cord
AC IN
PEN sensor