Check Damper Operation; Adjust Exhaust Adaptor; Mounting Plate To Wall - Tappan TMV151FSA Installation Instructions Manual

irlS[alla[iorl irlstrucuorl_5
B._,_. OUTSIDE TOP EXHAUST (Vertical Duct)
INSTALLATION OVERVIEW
B1. Attach Mounting Plate to Wall
B2. Prepare Top Cabinet
B3. Adjust Blower
B4. Check Damper Operation
B5. Mount Microwave Oven
B6. Adjust Exhaust Adaptor
B7. Connect Ductwork
BI. ATTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach
the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2, Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach
the toggle wings to 3_,, onto each bolt.
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
i i Toggle Wings
I
Mounting
Plate _1_
Wall
Bolt End
3, Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure to coincide bottom line of the
Mounting plate with Horizontal line of "Rear wall
Template" and then the Mounting plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
14