American DJ X-Move LED Plus R User Instructions page 5

X-Move LED Plus R
System Menu: When making adjustments you can press
ENTER to confirm your setup or you can wait 8 seconds for
automatic setup. To exit without making any adjustments
press the MENU button.
ADDR -
DMX Address Setting.
1. Tap the either the MENU, UP, or DOWN buttons until "ADDR"
is displayed, press ENTER.
2. The current address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
Press ENTER to set your desired DMX address.
SHND -
This will let you choose one of the four prepro-
grammed shows. See show descriptions below.
1. Tap the either the MENU button until "SHND" is displayed,
press ENTER. Either "SH 1", "SH 2", "SH 3" or "SH 4" will be dis-
played.
2. Tap the UP or DOWN buttons to find you desired show and
then press ENTER to confim and exit.
SHOWS:
Show 1 - For fixtures placed on the floor, the tilt movement
angle is 210°
Show 2 - For fixtures fixed to the ceiling or truss, the tilt move-
ment angle is 90°.
Show 3 - For fixtures placed on a table or stage. The beam is
projected at the audience's direction; i.e. in front of the stage.
Pan movement angle (left to right to left) is 160°. Tilt movement
angle is 90°.
Show 4 - For fixtures fixed to the ceiling or truss. The beam is
projected at the audience's direction; i.e. in front of the stage.
Pan movement angle (left to right to left) is 160°. Tilt movement
angle is 90°.
American DJ - www.americandj.com - X-Move LED Plus R Instruction Manual Page 9
®
System Menu X-Move LED Plus R
SLND -
master/slave configuration.
1. Tap the MENU button until "SLND" is displayed, press
ENTER. Either "SL 1" or "SL 2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to "SL 2", the fixtures will
now have contrast movement to each other.
SOUN -
1. Tap the MENU button until "SOUN" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to activate sound active mode, or
"OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
BLND -
1. Tap the MENU button until "BLND" is displayed, press
ENTER. Either Yes or No will be displayed.
2. To activate Blackout tap the UP or DOWN buttons until "Yes"
is displayed, press ENTER to confim. The fixture will now be in
Blackout mode. To deactivate Blackout mode, select "No" and
press Enter.
I PAN -
1. Tap the MENU button until "I PAN" is displayed, press ENTER.
Either NO or 1 will be displayed.
American DJ
This will let you set unit as a master or slave in a
Sound Active mode.
Blackout or Stand by mode.
Pan Inversion
- www.americandj.com - X-Move LED Plus R Instruction Manual Page 10
®
System Menu