Advertisement
Installation
Connect the plug to a socket provided with efficient earthing.
Electric
Or use the spare earthing wire supplied together with the
connection
machine and the earthing terminal located on the left-upper
corner of the back of your machine (Warning: this appliance
must be earthed as a safety measure according to the law).
Make sure that the voltage and frequency available
correspond with the values stated on the data plate located at
the back of the machine (power range:187-242V) and that the
electric system is dimensioned to withstand the maximum
current shown on the data plate. If the socket the machine is
connected to does not correspond with the plug, replace the
plug with a suitable one and avoid using adaptors or shunts
since they could cause overheating and burn out.The spare
eathing wire is absolutely not allowed to be connected to
water pipe,heating pipe or other kinds of pipes.
Connection
Connect the inlet hose to a cold water tap with a 3/4 gas
of tap and
threaded opening, and fit the filter and the rubber gasket
Loading
supplied with the washing machine. Check that it is tightly
screwed to the tap (Fig. 3).
Hose
If the water piping is new or has not been used for a long time,
before making the connection, let the water run until it is clear
and free from impurities.
This step is necessary to ensure that the incoming water
does not clog and possibly damage the machine.
Fig. 3
7
Advertisement
