Adjust Flame Height; Check Operation Of Oven Bake Burner; To Adjust Standard Burners - Whirlpool GW397LXUQ06 Installation Instructions Manual

• Check t hatthegasshutoff valves a resettothe"open"
position.
• Check t hatburner caps areproperly positioned onburner
bases.
Repeat start-up. If aburner does notlight a tthispoint, t urn the
control knobs t o"Off" andcontact your d ealer orauthorized
service c ompany forassistance.
Adjust Flame Height
Adjust the height of top burner flames. The cooktop "low" burner
flame should be a steady blue flame approximately 1A"(0.64 cm)
high.
A _ __-
/
B _ b-dL_L_JL_Jb-d"
/
A. Low flame
B. High flame
To adjust standard burners:
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
If the "low" flame needs to be adjusted:
1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem in the low position using a pair of pliers. Use
an 1/8"(3.0 mm) flat-blade screwdriver to turn the screw located in
the center of the control knob stem until the flame is the proper
size.
Check Operation of Oven Bake Burner
1. Remove the oven rack.
2. Using a Phillips screwdriver, remove the 2 oven bake burner
cover screws.
3. Lift up on rear of oven bake burner cover and remove.
4. Place cover on a protected surface.
A. Oven bake burner cover
B. Oven bake burner cover screws
5. Press BAKE. "BAKE" and "000" will flash in the display.
6. Press PRESETS 0 on the number pad.
7. Press BAKE again.
The igniter used to light the oven bake burner will glow. Once the
igniter is hot the oven bake burner should light. Under certain
conditions it may take up to 60 seconds for it to light.
Adjust Oven Bake Burner Flame (if needed)
1. Remove storage drawer.
2. Remove access panel (2 screws) located on the rear wall,
inside the storage drawer compartment.
3. Check the oven bake burner for proper flame.
This flame should have a 1/2"(1.3 cm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should
be clean and soft in character. No yellow tips, blowing or
lifting of flame should occur.
4.
If the oven bake flame needs to be adjusted, locate the air
shutter near the center rear of the range. Use a flat-blade
screwdriver to loosen the air shutter adjustment screw.
Rotate the air shutter until the proper flame appears. Tighten
air shutter adjustment screw.
3. Replace the control knob.
4. Test the flame by turning the control from "LO" to "HI,"
checking the flame at each setting.
5. Repeat above steps for each burner.
5.
6.
B
o_
A. Air shutter adjustment screw
B. Air shutter
Press CANCEL when finished.
Reinstall access panel and oven bake burner cover.
10