Moving The Range - Whirlpool SF370LEGN0 Installation Instructions Manual

30" freestanding sealed burner gas range with self-cleaning oven
Table of Contents

Advertisement

if rangedoes not operate:
[]
Check that the circuit breaker is not tripped
or the house fuse blown.
[]
Check that the power supply cord is plugged
into the wall receptacle.
[]
Check that gas line is turned on.
[]
See Use and CareGuide for troubleshooting list.
if you need assistance:
if you have questions about operating, cleaning
or maintaining your range:
[]
Refer to Use and Care Guide.
[]
Call the Consumer Assistance Center. Check
your Use and Care Guide for a tolPfree
number to call or call the dealer from whom
you purchased this appliance. The dealer is
listed in the Yellow Pages of your phone
directory under "Appliances -- Household --
Major -- Service and Repair."
if you need service:
Maintain the quality built into your range by
calling an authorized service company.
To obtain the name and number of an
authorized service company:
[]
Contact the dealer from whom you
purchased your range; or
[]
Look in the Yellow Pages of your telephone
directory under "Appliances -- Household --
Major -- Service and Repair;" or
[]
Call the Consumer Assistance Center.
The toll-free number is listed in your Use
and Care Guide.
When you call, you will need:
[]
The range model number.
[]
The range serial number.
Both numbers are listed on the model/serial
rating plate located on the frame behind the
storage drawer.
Moving the range:
Tip Over Hazard
A child or adult can tip the range and be
killed.
Connect anti=tip bracket to rear range
foot.
Reconnect the anti=tip bracket,
if the
range is moved.
Failure to follow these instructions can
result in death or serious
burns to
children
and adults.
When moving range, slide range onto cardboard
or hardboard to prevent damaging the floor
covering.
If removing the range is necessary for cleaning
or maintenance:
1. Remove the storage drawer.
2. Shut offthe gas supply to the range.
3. Slide range forward, away from the wall, just
far enough to disconnect the gas and electric
supply lines.
4. Slide range forward to complete cleaning or
maintenance.
anti-tip
bracket__
5. Making sure the anti-tip bracket is installed:
• Look for the anti-tip bracket securely attached
to floor.
, Slide range back so rear range foot is under
anti-tip bracket.
6. Check that range is level.
7. Reconnect gas line to range and check for
leaks.
8. Plug power supply cord into outlet. Reinstall
storage drawer.
Printed in U.S.A.
Part No. 8053366 Rev. A
Benton Harbor, Michigan 49022
@1998 Whirlpool Corporation

Advertisement

Table of Contents
loading

Table of Contents