Ipv6 Internet Connection Settings - TRENDnet TEW-812DRU User Manual

TRENDnet User's Guide
two networks are different, they are separate networks. In order to communicate
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see
on page 16).
2. Click on the Advanced tab.
3. Click on the Setup section and click on Routing.
4. Review the LAN/WAN Static Routes section. Click Apply to save settings.
• IP Address: Enter the IP network address of the destination network for the route.
(e.g. 192.168.20.0)
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your router management page"
• Subnet Mask: Enter the subnet mask of the destination network for the route.
(e.g. 255.255.255.0)
• Gateway: Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)
• Metric: Enter the metric or priority of the route. The metric range is 1-15, the
lowest number 1 being the highest priority. (e.g. 1 )

IPv6 Internet Connection Settings

Advanced > Setup > IPv6 Setting
IPv6 (Internet Protocol Version 6) is a new protocol that significantly increases the
number of available Internet public IP addresses due to the 128-bit IP address structure
versus IPv4 32-bit address structure. In addition, there are several integrated
enhancements compared to the most commonly used and well known IPv4 (Internet
Protocol Version 4) such as:
• Integrated IPsec – Better Security
• Integrated Quality of Service (QoS) – Lower latency for real-time applications
• Higher Efficiency of Routing – Less transmission overhead and smaller routing tables
• Easier configuration of addressing
Note: In order to use IPv6 Internet connection settings, it is required that your ISP
provide you with the IPv6 service. Please contact your ISP for availability and more
information about the IPv6 service.
1. Log into your router management page (see
on page 16).
2. Click on the Advanced tab.
3. Click on the Setup section and click on IPv6 Setting.
TEW-812DRU
"Access your router management page"
27