Table of Contents
Advertisement
Use this connection
if your cable system connects
directly to your TV/VCR
without a converter box.
With this connection
you 1) can use your TV/VCR
Remote Control to select channels 2) program
one
or more unscrambled
channels
for unattended
recording.
From Cable System
_l_n'_!
IF_I_ _oI_/:l
When using an external input signal, connect the
audio/video
cable to the AUDIO IN, VIDEO IN
jacks. To use the external input jack, selet the AUX
position. Press CH. "A" or '_r" button or enter "00"
with number button so that AUX appears on the
scr_n.
If your cable service supplies you with a converter
box you can use the basic _'onnection shown here.
(Not supplbd?
From Cable System
__T___,)_
_
CATV Be>:(Not supplied)
/
75-ohm
F"__
-
I
Coa_,Cablel f___
With this connection you can record and view any
channel including scrambled channels. However
channel selection must be made at the cable com-
pany converter box. This means
thai: channels
cannot be changed
usi_ng the TV/VCR
Remote
Control. Unattended
recording
is limited to one
channel at a time.
TO RECORD AND VI EW A SCRA_MBLED/UN-
SCRAMBLED
CHANNEL
1. Set the TV/VCR chant,el selector to the output
channel of the Cable Converter Box. (Ex. CH3)
2. Select the channel to l:,.,recorded
or viewed on
the Cable Converter Box.
AUX
Note to CATV system installer
This reminder
is provided
to call the CATV system installer's
attention
to Article 820-40 of the NEC
that provides guidelines
for proper grounding
and, in particular, specifies that the cable ground shall
be connected
to the grounding
system of the building as close to the point of cable entry as practical.
-12-
Advertisement
Table of Contents
