Usage Of The Drain Hose - Haier XQB70-10 User Manual

How to change the direction of the drain hose
1.Lean the machine down gently with the front
surface facing the ground. Loosen the eight
screws by a cross screwdriver.
Back
Front
2.Pull out the drain hose from the groove at the
right side.
Use groove at
this side after
direction changing

Usage of the drain hose

The drain hose shall drain smoothly
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not trample or press the drain hose.
If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
3.Extend the drain hose from the left side. Push the
drain hose into the groove with hands.
Bottom plate
Push the drain hose
into the groove with
hands at this point
Soft item
4.Install the bottom plate (as per indicated before),
then lift the machine up gently.
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 26mm, and the length shall
not exceed 1.5m.
If the extra hose is too long, cut it
either at A or at B point.
Before Using
Before Using
Page 3