Water Level - Haier XQB70-10 User Manual

Attention
Even there's no water in the tub, the
spinning will start after a certain period.
Do not use soak process for woolen
Wash the laundries that are prone to lose
colors separately from other laundries.
The pulsator will not rotate unless the
water is filled to selected water level.
Selection method of the procedure programs
Times of pushing Selected procedure
the"select"button program
0
Wash,rinse,spin
Wash(the washing
liquid remains in the
1
tub)
Wash,rinse(the
2 rinsing liquid remains
in the tub)
3
Rinse,spin
4
Spin(spin after drain)
Soak,wash,rinse,spin
5
If you push the "Process selector" button for 6 times, it will resume the original
mode, and it will circulate like that.
If you select the"Speedy wash" program, you have to set the full procedure of wash,
rinse and spin. The procedure can not be selected.
4 Press the "water level" button to select suitable

water level

After switching on the power, press the button " Water level " to select a water level according
to the load. Please refer to the paragraphs " Detergent standard dosages and water levels "
and " Button of Water level " on page 10.
laundries
.
Applicable procedure
When the common laundries
need washing, rinsing and
spinning.
Repeat using the washing
liquid
The laundry needn't spin to
avoid wrinkles
When the laundries need
rinsing and spinning after
manual washing
When the laundries need only
spinning after manual
washing (first drain then spin)
If the laundries are very dirty,
or the sleeve and collar are
dirty, first soak then wash
Page 9
Using process
Using process
Contents(the lighted indicators
indicate the programs about to run)
Soak Wash Rinse
Soak Wash Rinse
Soak Wash Rinse
Soak Wash Rinse
Soak Wash Rinse
Soak Wash Rinse
Water
level
Page 10
Spin
Spin
Spin
Spin
Spin
Spin