Advertisement
Wall Sleeve Brands:
#7Whirlpool
23, Deep
Rear,_Louvers
_60_ '
II
IIIIII
I IIIIIIIII
Top View
1. Redirect the louvers at the back of the wall sleeve as shown
opposite.
The use of pliers is recommended.
Because
of the increased
unit depth, first try dry fitting
using the method described
below:
1. Place (2) 1 W'x
1 W' x 14" seals against each side.
2. Gently slide unit in and check if amount
extending
from the
sleeve is sufficient
once the trim frame is attached.
3. If position is okay, remove unit and Proceed to the next step.
If not go to step 8.
4. Attach (1) 1 W' x 1 W' x 25" long seal in the center at the
top of the sleeve.
Remove the backing
paper and press into
position.
5. Attach (2) 1 W' x 1 W' x 14" seals to the left and right sides
of the sleeve.
6. Cut the 1 W' x 1 W' x 25" long seal to 14" long and attach it
vertically
to the rear grill 7" from the left side.
7. Attach the tapered spacer blocks to the floor of the sleeve.
Now go to step 13.
Use these next steps if the unit requires
extra extension
into the room.
8. Attach
1" x 3_,,x 14" long seal over the solid vertical portion
of the rear grille.
9. Attach (2) 4 W'x 3 W' x 1 W' foam blocks with the slot
overlapping
the seal above.
10. Install the divider into the slots of the foam blocks. You may
need to trim the length to size.
11. Cut the 1 W' x 1 W' x 25" seal to fit the top of the sleeve.
The pieces must be fitted flush to the edge of the divider.
12. Attach (2) 1 W' x 1 W' x 14" seals along the sides of the
sleeve again making sure all seals are flush.
13. Center unit & gently slide unit into sleeve.
14. Before sliding all-the-way
back, remove
1st screw from
front on left side of unit.
15. Remove the plastic washer from the screw.
16. Screw and attach the other end of the ground wire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet.
17. Slide the unit completely
to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
18. Seal & Frame the unit as described
on the last page of
these instructions.
9
Advertisement
