Advertisement
Extend
Window
Filler Panels and attach
to top angle
rail:
1. Carefully raise window to expose filler panel locking screws on top angle rail. Loosen screws so filler panels slide
easily.
2. Extend panels to fill window opening completely. Tighten locking screws on top (FIG. 16).
3. Close window behind top angle rail.
4. Attach the top angle rail to window frame: Use a 3132" drill bit to drill one hole through the hole in the middle of top
angle rail into the window frame, and drive one 112" HEX-HEAD
locking screw through the hole in the middle of top
FIG. 17
II
7a/16_!vL°Ch_gScrew
Attach Window
Filler Panels to Window
Frame
angle rail into the window frame as shown (FIG. 17).
FIG.16
1. Extend the window filler panels out against the window frame.
2. Use a 1/8" drill bit to drill a starter hole through the hole in the
top leg of each window filler panel and into the window sash
(Fig. 18A and Fig. 18B). Connect with one 1/2" long hex head
screw.
Install
Window
Sash Seal and Safety
Lock
1. Trim window sash seal to fit window width. Insert it into
space between upper and lower sashes as shown (FIG. 19).
2. Attach right angle safety lock to top window sash as
shown (FIG.20).
3.
Wi
c
FIG. 18A
A. 1/2" long hex head screw
B. left-hand Window Filler
Panel Top Leg
C. Window channel
1/2" long
HEX-HEAD
SCREW
""I'"_
FIG. 18B
"--.o[.._JI_YA
................
weather seals
If necessary, trim weather seals to needed length, peel
off protective backing, and use to plu! any gaps. See Fig. 18B.
SASH SEAL
A. 1/2" long hex head screw
Install Air Conditioner
into Cabinet
and Install
Front
Panel to Unit
1. Lift air conditioner and carefully slide into cabinet.
2. CAUTION: Do not push on controls
OR finned
coils.
3. Be sure air conditioner is firmly seated towards rear of cabinet.
4. Reconnect electronics plug if present. Position vent control lever so that it will thread into its channel in the front
panel (see FIG.21 ). Hook front panel top tabs into slots on cabinet top, and rotate front panel down so that side tabs
snap into place on cabinet. Insert 4 previously removed screws through front panel and into air conditioner.
5. Insert air conditioner filter. Reinstall the front grille by hooking bottom tabs into slots on Front Panel bottom, then
rotating grille up to snap into place.
Advertisement
