Table of Contents
Advertisement
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Extend the drain hose from the side of spin tub
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Take the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the
side of the spin tub in the order of (1)~(3), heading
for the side of the spin tub. (See to Figure 3).
Embed the drain hose into the groove with
hands. Take care not to damage the drain
hose in fastening the fixing clamp.
Extend the drain hose from the rear side
Take out the drain hose from the fixing groove.
Extend it fromthe rear side as per the direction
of the arrow. (When the drainhose is extended
from the rear side, it can be hung on the
point for drain hose at the two sides of the cabinet.)
(See to Figure 4).
Install the water inlet hose; Select the water level
Insert the water inlet hose into the
water-filling entrance, then push the
water-filling jointer into the wash
water-filling entrance on the major
frame.(To dismantle the water inlet
pipe, just push the control handle
as indicated in the figure and pull it out)
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
Soft item
Soft item
Extend to the
spin tub side
Water inlet hose
Push
Control handle
Water level
indicator
Maximum Max
about 43L
Med
Medium
about 36L
Min
Minimum
about 30L
Back
Front
Figure 1
Figure 2
Embed into the
groove in turn
Figure 3
Figure 4
Water-filling jointer
Wash water-filling entrance
5
Advertisement
Table of Contents
