XPB50-AS XPB50-BS(with pump Air BubbleTwin-tub Washing Machine Please read this manual carefully before using. Please retain it for future reference. Please check if the receptacle is earthed relia - ly before usage to guarantee your safety. The manufacturer is not responsible for any risks occurred owing to disobey these stipulatio-ns.
Names of the parts Buzzer Water-filling entrance Water inlet selector handle Wash selector Wash timer Control panel Overflow filter Quick water-filling entrance Cascade outlet Water level adjusting lever Lint filter Valve cover Pulsator Wash tub Drain hose Base frame Accessories Water-filling jointer Water inlet hose (one piece)
Safety precautions Be sure to use three-phase receptacle. Earth the earthing terminal of the receptacle reliably. Earth If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean.
Page 4
Safety precautions Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine.
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose(Only for XPB50-BS The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause...
How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Extend the drain hose from the side of spin tub Put soft items on the ground. Lean the machine down gently with the front surface facing the ground.
Introduction of the major function The machine has good comprehensive performance, and nice appearance. In the respect of increasing the clean rate, it creates the air suction washing method. The spinning of the pulsator automatically produces large quantity of bubbles, which can strengthen the activity of the detergent remarkablly.
. Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose(Only for XPB50-AS) or put the drain hose up the suitable position( Only for XPB50-BS)
Using process Using process The musts in washing The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity.
Usage of the detergent How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to lose color. The whitener shall not touch the laundries directly.
Washing sequence Wash timer Wash selector (To set to below 2 minute, (Soft current, first set to 5 minute then strong current) turn it back. it can increase the service life of the timer). STRONG SILK WOOL SOFT COTTON LINEN WASH SELECTOR WASH TIMER Wash...
Page 12
Midway spinning Put the laundries into the spin tub evenly and smoothly. Spin (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. Push Gland The laundries Proper are slanting (2) Close the inner and outer cover of the spin tub. (3) Spin for 1-2 minutes.
Page 13
Rinsing Rinse with water-filing 1.Put the laundries into the wash tub. Select suitable current according to the laundries. 2.Adjust the water level Set the water level with water level adjusting lever according to the laundries quantity. Then fill suitable water continuously. 3.Rinse Adjust the wash timer to 5-7 minutes to do rinsing.
Page 14
Spinning 1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and outer cover of the spin tub. 3. Spin Select suitable spin time according to the laundries, and do spinning. During spinning, if there's abnormal sound, it is generally owing to slanting placement of the laundries.
Disposal after washing After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing.
Page 16
Cleaning the overflow filter Too much lint on the overflow filter will influence the normal usage of the machine. Please clean it every two months. Take off the overflow filter. As indicated in the figure, nip the elastic fixing claw and pull it to the direction of the arrow to take it off.
Trouble-shooting Answer to question If the laundries fall to the outer side of the spin tub If the laundries fall to the outer side of the spin tub, please take them out immediately. 1.Dismantle As indicated in the figure, push the point marked with "...
Page 18
Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company.
Packing list Name User's manual Water inlet hose Water-filling jointer Gland Lint filter Twin-tub washing machine Quantity Storage position Inside the document bag Inside the accessory bag Inside theaccessory bag Inside the accessory bag Inside the document bag...