Singer 6201; 6211 User Manual page 25

ATTACHING THE BUTTON
Flat buttons can be sewn on quickly and easily using the plain zigzag stitch. A
special button sewing foot (H), may be purchased at your sewing center.
RECOMMENDED SETTINGS
Stitch Selection: Zig-Zag Stitch
Needle Position
Stitch Width: To suit Button
Needle Plate: General Purpose (A)
4Attach
Feed Cover (F)
Before you can attach a button, the
bobbin thread must be brought up
through the hole in the feed cover.
1 Set stitch width at
! and needle
position selector at 1 . Position
button under foot and lower the
needle into the center of the left
-t •hole. Lower the toot. Turn hand
Lwheel
toward you until needle
rises out of button and is above the
foot.
2. Move stitch width selector until
needle is over the other hole in the
button. Then, when you begin to
stitch, the needle should enter into
the right hole of the button. Take six
Lor
more zig-zag stitches to attach
button and finish with the needle on
the left side.
3, To fasten stitching, adjust width to
-
n tk three or forstitches,
and take the rfour tchs
Remove work, draw threads to
underside, fasten, and trim.
23