Bryston BP17 Owner's Manual
Hide thumbs Also See for BP17:

Advertisement

• SAFETY INSTRUCTIONS ........................................................................1
• WARRANTY
• INTRODUCTION ....................................................................................... 2
• SETUP
• WIRED REMOTE CONTROL: RS232 ................................................ 3
• ANALOG AUDIO OUTPUTS
• 12V TRIGGER CONNECTOR
• PROGRAMMING THE 12V TRIGGER ..................................................... 4
• HAND-HELD IR REMOTE CONTROL
• DIGITAL-TO-ANALOG CONVERTER OPTION ....................................... 5
• MOVING-MAGNET PHONO STAGE OPTION
BP17
OWNER'S MANUAL

TABLE of CONTENTS

Page

Advertisement

Table of Contents
loading

Summary of Contents for Bryston BP17

  • Page 1: Table Of Contents

    • CHASSIS GROUND CONNECTOR • 12V TRIGGER CONNECTOR • AUXILIARY IR INPUT • LED STATUS INDICATORS • REMOTE ON/OFFCONTROL • PROGRAMMING THE 12V TRIGGER ............. 4 • HAND-HELD IR REMOTE CONTROL • PROGRAMMING THE BR2 IR REMOTE CONTROL • SENDING CODES to the BP17 via the IR REMOTE CONTROL • WIRED RS232 REMOTE CONTROL • BYPASS MODE • DIGITAL-TO-ANALOG CONVERTER OPTION ........5 • MOVING-MAGNET PHONO STAGE OPTION • SPECIFICATIONS • FRONT & REAR PANEL DETAILS ............6 • EXTERNAL DIMENSIONS & RECOMMENDED CLEARANCE ENVELOPE .... 7...
  • Page 2: Safety Instructions

    Bryston dealer accompanies the re-sale. The copy of the bill of sale to any subsequent owner need ONLY include the Name of the Bryston Authorized Dealer and the Model and Serial number of the Bryston product The warranty will only be honored in the country of the original purchase unless otherwise pre-authorized by Bryston.
  • Page 3: Introduction

    HEADPHONE JACK: There is a quarter inch headphone output jack avail- able on the front panel of the Bryston BP17 Preampli- SETUP RECOMMENDATIONS fier. Inserting the headphone jack mutes PREAMP OUT automatically. You can adjust the volume setting of...
  • Page 4: Wired Remote Control: Rs232

    Balance can be adjusted in 1dB incre- 12 VOLT TRIGGER CONNECTOR: ments to up to -6dB in either direction. These 12Vdc control outputs allow the BP17 to exert Stepping past -6dB in either direction will on/off control over compatible equipment. See “RE- mute that channel fully and the LED for MOTE ON/OFF CONTROL”...
  • Page 5: Programming The 12V Trigger

    T2 going active. To completely disable the backlight, enter the 3 digit • While pointing the remote control at the BP17, code “797” as follows: press the CODE button, followed by the three digit 1) Press and hold the CODE button for 5 seconds. Re- code “247”...
  • Page 6: Wired Rs232 Remote Control

    BYPASS mode can only be set (or standard BP17 model later if required by your Bryston reset) by sending the 3 digit code “245” to the BP17 either dealer. from the handheld IR remote control or via the RS-232 Bryston’s MM Phono section features state-of-the-...
  • Page 7: Front & Rear Panel Details

    BP17 PREAMPLIFIER...
  • Page 8: External Dimensions & Recommended Clearance Envelope

    BP17 PREAMPLIFIER 300016-2 20121031...

This manual is also suitable for:

Bp17-daBp17-p

Table of Contents