Restoring The Default Configuration And Password - NETGEAR WNR2000v2 User Manual

Wireless-n 300 router
Hide thumbs Also See for WNR2000v2:
Table of Contents

Advertisement

If your wireless network appears, but the signal strength is weak, check these conditions:
Is your router too far from your adapter, or too close? Place the computer that has the adapter
near the router, but at least 6 feet away, and see whether the signal strength improves.
Is your wireless signal obstructed by objects between the router and your adapter? See
"Optimizing Wireless Performance" on page

Restoring the Default Configuration and Password

This section explains how to restore the factory default configuration settings that reset the
router's user name to admin, the password to password, and the IP address to 192.168.1.1.
Warning: These procedures erase all current configuration settings.
You can erase the current configuration and restore factory defaults in two ways:
Use the Erase function of the router. To use the Erase function, see
Configuration" on page
Use the restore factory settings button on the rear panel of the router. Use this method for cases
when the administration password or IP address is not known.
To use the restore settings button:
1. Locate the restore factory settings button on the rear panel of the router.
2. Use a sharp object such as a pen or a paper clip to press and hold the restore factory settings
button for about 5 seconds, until the Power light begins to blink.
3. Release the restore factory settings button, and wait for the router to restart, and for the Power
light to stop blinking and become solid green.
The factory default settings will be restored so that you can access the router from your Web
browser using the factory defaults.
If the wireless router fails to restart, or the Power light continues to blink or turns solid amber, the
unit might be defective. If the error persists, you might have a hardware problem and should
contact Technical Support at http://www.netgear.com/support.
Troubleshooting
NETGEAR Wireless-N 300 Router WNR2000v2 User Manual
5-15.
6-9.
v1.0, January 2010
"Erasing the
7-12

Advertisement

Table of Contents
loading

Table of Contents