Installing Your Refrigerator; Unpacking Your Refrigerator; Proper Air Circulation; Electrical Requirements - Haier HSW02C User Manual

Haier compact refrigerator user manual
Hide thumbs Also See for HSW02C:
Table of Contents

Advertisement

Available languages

Available languages

English
English

Installing Your Refrigerator

Unpacking Your Refrigerator

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the refrigerator accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the refrigerator.

Proper Air Circulation

To assure your refrigerator works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections.
The following are recommended clearances around the refrigerator:
Sides...............3/4" (19mm)
Top....................1" (25mm)
Back..................1" (25mm)
Electrical Requirement
Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with
proper grounding to power the refrigerator.
Avoid the use of three plug adapters or cutting off the third grounding in
order to accommodate a two plug outlet. This is a dangerous practice
since it provides no effective grounding for the refrigerator and may result
in shock hazard.

Use of Extension Cords

Avoid the use of an extension cord because of potential safety hazards
under certain conditions. If it is necessary to use an extension cord, use
only a 3-wire extension cord that has a 3-blade grounding plug and a 3-
slot outlet that will accept the plug. The marked rating of the extension
cord must be equal to or greater than the electrical rating of the appliance.

Install Limitations

• Do not install your refrigerator in any location not properly insulated or
heated e.g. garage etc. Your refrigerator was not designed to operate in
temperature settings below 55˚ Fahrenheit.
• Select a suitable location for the refrigerator on a hard even surface away
from direct sunlight or heat source e.g. radiators, baseboard heaters,
cooking appliances etc. Any floor unevenness should be corrected with the
leveling legs located at the bottom.
English
5

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Hsw02

Table of Contents