Page 1
The manufacturer keeps on developing various types of refrigerators, so he has the right to modify designs, products and technical data without further notice. MODEL HR-180T1 HR-180T2 REFRIGERATORS OPERATING INSTRUCTIONS...
Page 2
FIGURATION OF THE REFRIGERATOR 1. Low bottle support 3. Vegetable box 5. Drip tray 7. Thermostat The manufacturer reserves the right to improve the product from time to time without further notice. 2. High bottle support 4. Shelf 6. Evaporator...
Page 3
NOTICE The power supply HR-180T1 127v,60HZ HR-180T2 220V, 50/60Hz Single phase. It is not recomended to use any extention cords. Connect the appliance with a properly earthed three-wire plug and socket with a special use. SETTING UP The appliance can be placed with its rear panel directly against the wall.
Pos. “1”,Pos. “4”.Pos. “0” shows the power is cut off. STORING FOOD The temperatures in different positions inside the refrigerator are different due to different refrigeration distribution.Thus when store food, select proper position to meet your needs.
NOTES ON STORAGE Where necessary, food should be packed in bags, avoiding giving off strong odours or getting wet or dry. Hot food or liquid must be allowed to cool to room temperature before placing in it. CLEANING The appliance can only be cleaned at drawn network plug. Clean it with lukewarm water containing a little detergent.
Page 6
DEFROSTING 4~6mm NOTES If the appliance remains out of use for some time, pull out the plug to disconnect the appliance from power supply. Clean the interior as described above to prevent odours from forming inside. When defrosting, switch off the appliance.
Page 7
In the event of a fault occurring during operation, check first if the fault is due to an operation error. You can repair the following faults yourself. The appliance does not run. The temperature inside the appliance is not low enough. Excessive noise from the appliance.
LAMP AND LAMP REPLACEMENT Lamp: HR-180T1 127V,15W. Lamp holder: E14 (lamps exceeding 15W must not be used) When replacing the lamp: * Unplug to disconnect the power and remove the water tray. * Press the positioning pin of the lamp...