Husqvarna Viking Prelude 350 User Manual page 32

Maintenance
Care of the Machine
To keep your sewing machine operating satisfac-
torily, it requires, like other precision machines,
regular cleaning. No lubrication (oiling) is needed.
Turn off the main switch.
Clean the Bobbin Area
Remove the presser foot and slide off the bobbin
cover. Lower the feed teeth. Place the stitch plate
opener on the brush, and then in the recess at the
rear of the stitch plate. Turn toward you to pop
off the stitch plate. Clean the feed teeth with the
brush.
Cleaning Under the Bobbin Area
When lint builds up, the area under the bobbin
case must be cleaned.
Remove the bobbin case holder (1) covering the
front part of the bobbin case (2). Remove the
2.
bobbin case by lifting it up. Clean with the brush.
Replace the bobbin case and the bobbin case
holder.
1.
Replacing the Stitch Plate
With feed teeth down, place the stitch plate about
5 mm in front of the rear edge and push it back.
Slide on the bobbin cover. Raise the feed teeth.
30