Electrolux EI30BM60MSA Installation Instructions Manual page 7

Installation Instructions
I_1 DETERM INING WALL PLATE LOCATION UNDER YOUR CABINET
Plate position--beneath flat bottom
cabinet
ILl
tJ
I t_ c !ll ......
_ i _i I uraw a vertical line on
"_. the wall at the center of
At least
30"
_1 the 30" wide space.
Tape the Rear Wall
Template onto the wall
matching the centerline
and touching the
bottom of the cabinet.
Plate position--beneath framed
recessed cabinet bottom
I
I I
I I
I I
C
33" to Cooktop
Draw a vertical line on the wall at the center of the
30" space.
Tape the Rear Wall Template onto the wall
matching the centerline and touching the bottom
binet frame.
Plate position--beneath recessed
bottom cabinet with front overhang
!;
Draw a line on the
back wall equal to the
depth of the front
overhang.
33" to Cooktop
Your cabinets may have decorative trim that
interferes with the microwave installation. Remove
the decorative trim to install the microwave properly
and to make it level.
THE MICROWAVE MUST BE LEVEL.
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no
back or side frame, install the mounting plate down
the same distance as the front overhang depth. This
will keep the microwave level.
[_ Measure the inside depth of the front overhang.
[_ Draw a horizontal line on the back wall an equal
distance below the cabinet bottom as the inside
depth of the front overhang.
[_ For this type of installation with front overhang
only, align the mounting tabs with this horizontal
line, not touching the cabinet bottom as described
in Step D.
7