Crosley CFW4500KW0 Installation Instructions Manual page 9

Leveling your washer
leveling the washer.EXcessive noise and vibration can be prevented by properly
1. For free standing installation and with the washer within I
4 feet (1 m)of its final location, place a level on top of the
washer.
2. Use adjustable pliers to adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable
corner-to-corner, lower 3. Pressdown on alternate corners and sides and feel for the
washerslightest sits movement, solidly onAdjust the floor theon appropriate ALL four legs. leg(s)Keep so the the
leveling leg extension at a minimum for best performance
of the washer.
For pedestal installations, see additional installation
instructions included with the pedestal.
Connecting inlet water
1. Run some water from the hot and cold faucets to flush the
water lines and remove particles that might clog the water
valve screens and to determine which faucet is hot and
which is cold supply.
2. Remove the inlet hoses and rubber washers from the
plastic bag located in the drum of the washer and install
the rubber washers in each end of the inlet hoses.
RUBBERWASHERS
MUST BE PRESENT
USE ONLY
NEW HOSES
3. Connect the HOT inlet hose to the HOT inlet connection
on the washer and the COLD inlet hose to the COLD inlet
connection on the washer. Tighten by hand until snug.
Then tighten each supply connection another 2/3 turn
with pliers. Do not cross thread or over-tighten these
connections.
4. Connect the HOTinlet hose to the HOTwater supply and
the COLD inlet hose to the COLD water supply. Tighten
by hand until snug. Then tighten each supply connection
another 2/3 turn with pliers.
5. Turn on the water and check for leaks.
J
HOT
COLD
f