Advertisement
Available languages
Available languages
2.
3.
.
Turn on Electrkat
Power and Open Main Shutoff
Gas Valve
Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power. To check for proper lighting:
a.
Push in and turn a surface burner knob to the
LITE position. You will hear the igniter sparking.
b.
Tile surface burner should light when gas is
available to the top burner. Each burner should
light within four (4) seconds in normal operation
after air has been purged from supply lines.
Visually check that burner has lit.
c.
Once the burner lights, the control knob should
be rotated out of the LITE position.
There are separate ignition devices for each burner.
Try each knob separately until all burner valves have
been checked.
Adjust the "LOW" Setting
of Surface Burner
Valves (see Figure 12)
a.
Push in and turn each control to LITE until burner
ignites.
b.
QukMy
turn knob to LOWEST POSITION.
c.
If burner goes out, readjust valve as follows:
Reset control to OFF. Remove tile surface burner
control knob, insert a thin-bladed screwdriver
into the hollow valve stem and engage the
slotted screw inside. Flame size (:an be increased
or decreased with tile turn of the screw. Adjust
flame until you (:an quickly turn knob from LITE
to LOWEST POSITIONwithout
extinguishing the
flame. Flame should be as small as possible
without
going
out,
5.
Operation
of Oven Elements
The oven is equipped with an electronic oven control. Each
of the functions has been factory checked before shipping.
However, it is suggested that you verify the operation of
the electronic oven controls once more. Refer to the Use
and Care Guide for operation. Follow the instructions for
the Clock, Timer, Bake, Broil, Convection (some models)
and Clean (some models) functions.
When checking oven element operation,
do not touch the elements. They will be hot enough to
cause serious burns.
Bake-After
setting the oven to 350% (I 77°C) for baking,
the lower element in the oven should become red.
Broil-When
tile oven is set to BROIL, the upper element
in tile oven should become red.
Clean (some models}-When
the oven is set for a self-
cleaning cycle, the upper element should become red
during the preheat portion of the cycle. After reaching
the self-cleaning temperature, the lower element will
become red.
Convection
(some modeJs)-When
the oven is set to
CONV. BAKE/ROAST at 350% (177°C), both elements
cycle on and off alternately and the convection fan will
turn. The convection fan will stop turning when the oven
door is opened during convection baking or roasting.
When All Hookups
are Complete
Make sure all controls are left in the OFF position.
Model
and Serial Number
Location
Tile serial plate is located on the drawer side frame.
When ordering parts for or making inquiries about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your range.
Before
You Call for Service
Read the Avoid Service Checklist and operating
instructions in your Use and Care Guide. It may save you
time and expense. Tile list includes common occurrences
that are not the result of defective workmanship or
materials in this appliance.
Refer to the warranty and service information
in your Use
and Care Guide for our phone number and address.
Please (:all or write if you have inquiries about your
range product and/or need to order parts.
Advertisement
