Before You Call For Service; Model And Serial Number Location; Care & Cleaning - Frigidaire FGFL88ACC Installation Instructions Manual

11.Air Shutter-Broil Burner
The approximate flame length of the broil burner is 1 inch
(distinct inner, blue flame).
To determine if the broil burner flame is proper, set the oven
to broil.
If the flame is yellow in color, increase air shutter opening
size. (See "2" in illustration above.) If the flame is a distinct
blue, reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in illustration above),
reposition air shutter, and tighten lock screw.
Before You Call for Service
Read the "Before You Call" and operating instruction sections
in your Use & Care Manual. It may save you time and
expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this
appliance.
Refer to the warranty in your Use & Care Manual for our toll-
free service number and address. Please call or write if you
have inquiries about your range product and/or need to order
parts.
12.Make Sure
Range
is Level.
Level the range by placing a level horizontally on an oven
rack. Check diagonally from front to back, then level the
range by either adjusting the leveling legs or by placing shims
under the corners of the range as needed.
13.After installation is complete, make sure all
controls are left in the OFF position.
Model and Serial Number Location
For sealed burner ovens, the serial plate is located on the
right-hand surface of the oven front frame at the storage or
warmer drawer; or the lower panel area.
When ordering parts for or making inquires about you r range,
always be sure to include the model and serial numbers and
a lot number or letter from the serial plate on your range.
Your serial plate also tells you the rating of the burners, the
type of fuel and the pressu re the range was adjusted for when
it left the factory.
Care, Cleaning and Maintenance
Refer to the Use & Care Manual for cleaning instructions.
If removing the range is necessary for cleaning or
maintenance, shut off gas supply. Disconnect the gas and
electrical supply. If the gas or electrical supply is inaccessible,
lift the unit slightly at the front and pull out away from the wall.
Pull only as far as necessary to disconnect the gas and
electrical supply. Finish removing the unit for servicing and
cleaning. Reinstall in reverse order making sureto level the
range and check gas connections for leaks. See page 3,
step 1 for proper anchoring instructions.
Serial plate IocaUon
Open storage
or remove lower panel
(on some models)
8