Table of Contents
Advertisement
Operation of Surface Burners
6.
Installation
of Burner Cap Assembly
Your range is equipped with any combination of the sealed
burners. Refer to the chart to find your surface burner and
surface burner cap configuration. Be sure to place the correct
Possible Surface Burnerand Cap configurations:
12k
burner cap at on all four surface burners.
Install the parts shown below at all four surface burner
locations:
1st- Install the surface burner pans (if equipped); 2rid -install
the surface burner heads; 3rd - install the surface burner caps
and 4th; install the burner grates.
Surface
Burner
Grate
Electric
Ignition Surface Burners
Operation of electric igniters should be checked after range
and supply line connectors have been carefully checked for
leaks and range has been connected to electric power.
a.
To check for proper lighting, push in and turn a surface
burner knob counterclockwise
to the LITE position.
You will hear the igniter sparking.
b,
The surface burner should light when gas is available to
the top burner.
Purge air from supply lines by leaving
knob in the LITE position until burner ignites.
Each
burner should light within four (4) seconds in normal
operation after air has been purged from supply lines.
c.
Visually check that burner has tit. Once the burner lights,
the control knob should be turned outofthe LITE position.
d.
There are separate electrodes (igniters) for each burner.
Try each knob separately until all burner valves have
been checked.
Note: Knob styles may vary from those pictured below.
c.
If burner goes out, reset control to OFF.
Suitace
Burner
Cap
Surface
Burner
Head
OFF ..LITE..hi 6 5 4 3 2 Io
Orifice
Removable
Bumer
Drip Pan
_some
models)
6
Advertisement
Table of Contents
