Advertisement
B,
Drill Pilot Holes and Fasten Bracket - Drill a 1/8" pilot
hole where screws are to be located. If bracket isto be
mounted tothe wall, drillpilothole at an approximate20 °
downwardangle. If bracket isto be mountedto masonry
or ceramic floors,drilla 5/32" pilothole 1-3/4" deep. The
screws provided may be used in wood or concrete
material. Use a 5/16" nut-driveror flat head screwdriver
to secure the bracket in place.
FASTEN BRACKET (W*_LOr FLOOr M OUNTING)
--_l
1<--1-1/4"Max.
Leveling Leg
Mount
Floor Mount
_
I--Anti-Tip Bracket
FASTEN BRACKET
(FLOOR
MOUNTING
ONL'd
Leveling Leg --
N
FloorlM°unt
_i
LAntI'Tip
Bracket
- More Than
1-1/4"
Wall
C. Level and Position Range - Level range by adjusting
the (4) leveling legs with a wrench. Note: A minimum
clearance of 1/8" is required between the bottomof the
range and the leveling leg to allow roomfor the bracket.
Use a spiritlevel to checkyour adjustments. Slide range
back into position. Visually check that rear levelingleg is
inserted into and fully secured by the Anti-Tip Bracket by
removing lower panel or storage drawer. For modelswith
a warmer drawer or broiler compartment, grasp the top
rear edge of the range and carefully attempt to tilt it
forward.
2.
Electrical
Connection
Requirements
This appliancemustbe properlyinstalledand groundedbya
qualifiedtechnicianin accordancewith theNationalElectrical
Code ANSI/NFPA No. 70-latest edition--and localelectrical
code requirements,
This appliance may be connected by means of permanent
"Hard Wiring" or "Power Supply Cord Kit."
When hard wiring, do not leave excess wire in range
compartment. Excess wire in the range compartment may
not allow the access cover to be replaced properly, and could
create a potential electrical hazard if wires become pinched.
Connect only as instructed under'_/IRING INSTRUCTIONS"
in section 4A or 4B. When using flexible conduit or range
cable use flex connector or range cable strain relief.
NOTE: Only use copper wire inconnectiontoterminal block.
(17ram)
Range Side
%
%
Advertisement
