Removing The Mounting Plate; Finding The Wall Studs - GE JVM1950 Installation Instructions Manual

Installation Instructions
I-- PLACEMENT OF THE MOUNTING PLATE
E]
REMOVING THE OVEN FROM
THE CARTON/REMOVING
THE MOUNTING PLATE
%
[]
Remove the box containing the installation
instructions, filters, exhaust adaptor, damper
and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
Fold back all 4 carton flaps fully against carton sides.
Then carefully roll the oven and carton over onto
the top side. The oven should be resting in the
Styrofoam.
Styrofoam
%
%
%
Pull the carton up and off the oven.
The mounting plate is attached to the back of the
oven. Remove the two screws holding it to the oven.
The plate will be used as the rear wall template and
for mounting the oven to the wall.
Set the oven upright. Remove and properly discard
plastic bags and Styrofoam.
Open the oven door and remove the styrofoam
pack from inside the oven. Remove the tape
covering the turntable hub.
FINDING THE WALL STUDS
Cente_
Wall
Studs
[_ Find the studs, using one of the following methods:
A. Stud finder - a magnetic device which locates nails.
OR
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate
a stud location.
[_] After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the stud.
Then place o mark halfway between the edges.
The center of any adjacent studs should be 16" or 24"
from this mark.
[_] Draw a line down the center of the studs.
IMPORTANT: The microwave must be connected to at
least one wall stud.
8