GE JT3000SF1SS Installation Instructions Manual page 3

CUTOUT FOR DOUBLE OVENS (2THERMAL OVENS)
NOTE: If the cabinet does not have a front frame and the sides are less than sA"(1.9 cm)
both sides equall_h.i
Junction
BO×
Location
(junction
/ boxmay
/be located
in adjacent
cabinet)
l
J
O _
t
F
G
t
hick, shim
i
r
%
r
i
Dim. Description 27" Double Oven 30" Double Oven with 30" Double Oven
Pedestal without Pedestal
A Cabinet Width 27" (68.6 am) 30" (76.2 am) 30" (76.2 am)
B Cutout Width 25" (63.5 cm) min. 28½" (72.4 cm) min. 28½" (72.4 cm) min.
25¼" (64.1 cm) max. 28%" (72.7 cm) max. 28%" (72.7 cm) max.
C Cutout Height 4%_d' (126.2cm) min. 5113/S' (131.6 cm) min. 50 ¼" (127.64cm)
50½" (127.5 am) max. 51_/_d' (151.9 am) max.
D Overlap of Oven 1" (2.5 am) _½d' (1.75 am) _4d' (1.75 am)
Over Side Edges
of Cutout
E Clearance to 23" (50.8 cm) min. 23" (53.3 cm) min. 23" (53.3 cm) min.
Adjacent Corners,
Drawers, Walls, etc.,
When Door/sOpen _ ,
F Overlap of Oven 1" (2.5 am) rain. 1" (2.5 cm) min. 1" (2.5 cm) min.
Top of Cutout (1¼"(5.2 cm) for PT9550) (1¼"(5.2 cm) for PT9550)
G Overlap of Oven 1" (2.5 cm) min. 11/4" ( 5.2 cm) 11/4" ( 5.2 cm)
Bottom of Cutout
H Junction Box 8sA " (22.2 cm) max. 9½" (24.1 cm) max. 9½" (24.1 cm) max.
Locat!on _ rights!de only _ rights!de only . rights!de only
J Height to Bottom 44" (111.8 cm) 47" (i19.4 cm) 47" (i19.4 cm)
of Junction Box
K Recommended 15¼" (55.7 am) 12" (50.5 am) 12" (50.5 am)
Cutout Location
from Floor
Continue to Section 3.
J31-i0856-i Jo -is GE
CUTOUT FOR INSTALLATION OVER A WARMING DRAWER
NOTE: Install theoven onlywithspecific models listed on the label located on topofthe oven.
NOTE: Additional clearances between cutouts may be required. Check tobe suretheoven supports
above theWorming Drawer location d o notobstruct t herequired interior depth and height.
When installing a Worming Drawer below a single ordoubleoven,a separate 120V,60 HZ,properly
grounded receptacle m ust be installed. Refer to installation instructions pocked with
theWorming Drawer for specific installation requirements.
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement
Continue to Section 3 for DWO with Pedestal. Otherwise, continue to Section 4.