GE JT3000SF1SS Installation Instructions Manual page 2

r_==_ CUTOUT FOR SINGLE OVENS IN WALL CABINET
NOTE: If the cabinet does not have a front frame and the sides are less than sA" (1.9 cm) thick, shim
both sides equally to establish the cutout width.
These ovens
are not
approved for
stackable
installations.
Opening
Between Inside
Wails Must be
at Least 28-1/2"
(724 cm) Wide
H
Sideby-Side Installations
Installtwo ovens in separate cutouts
Center Line Center Line
] so.s"177scrnl ]
I 30" models I
] 2T' (68.58crn) ]
I 27" modes !
I !
--I
Cutout- Cutout -
observeall observe all
dimensionsand dimensionsand
requirements requirements
"---_1 I_== 2"Is1cm/r_in
Junction
Box
Location
(junction
box may
Jbe located
in adjacent
cabinetl
: --T
22" (559 __-=_lm
cm} Hin. to
_ Bottom of
J Junction
J BOX
J
..... ~%:;, ....
-" " Cutou/Depth
(59.7cm} Nlin.
Note: Allow
1/4" (0.64 cm)
clearances
from side
edges of oven
door.
_____B___-_
t
F
G
............................... L ......
t
C
m
4_
Recommended
Cutout Location
from Floor
32 1/2" (826 cm)
A ---d
Dimension Dimension Description 27" Single Oven 30" Single Oven
A Cabinet Width 27" (68.6 cm) 30" (76.2 cm)
B Cutout Width 25" (63.5 cm) min. 28½" (72.4 cm) min.
25½" (64.1 cm) max. 28sA " (72.7 cm) max.
C Cutout Height 27%" (70.2 cm) min. 27½" (69.2 cm) min.
28½" (71.4 cm) max. 27s4d ' (69.4 cm) max.
D Overlap of Oven Over 1" (2.5 cm) _¼_d'(1.75 cm)
Side Edges of Cutout
E Clearance to 23" 150.8 cm) min. 23" 153.3 cm) min.
Adjacent Corners,
Drawers, Walls, etc.,
When Door Is Open
F Overlap of Oven 1" 12.5 cm) min. 1" 12.5 cm) min.
Top of Cutout (11/4' ' 13.2 cm) for PT9050)
G Overlap of Oven 1" (2.5 cm) min. 1½" (3.2 cm)
Bottom of Cutout
H Junction Box Location 8¾" (22.2 cm) max. 9½" (24.1 cm) max.
right side only right side only
CUTOUT FOR SINGLE OVENS - UNDER COUNTER
NOTE: These ovens are only approved to be installed under the specific models as labeled on the unit.
Gas or Electric Cooktops May Be Installed Over This Oven.
See Cooktop Installation instructions for Cutout Size, 240V/208V
See Label on Top of Oven for Approved Models. Junction Box
Location (junction
box may be
in adjacent cabinet)
25" (63.5 cm)
Gas and Electrical Connections
for Gas Cooktop Must be Located
in an Adjacent Accessible
Location to the Right
MUST SUPPORT 200 Ibs. (60 kg) FOR SINGLE OVENS
MUST SUPPORT 375 Ibs. (170 kg) FOR DOUBLE OVENS
Side-by-Side Installations
Install two ovens in separate cutouts.
center Line CenterLine
I 30.5" (775 cm) 30" models
36" (91.4 cm)
Countertop
Height
Cutout - observe
all dimensions and
requirements.
__q
JL
Cutout = observe
all dimensions and
requirements.
_=2" (5.l cm) Nlin.
NOTE:One cooktop may be centered over either oven in
the side-by-side installation.
Dimension Dimension Description 27" Single Oven 30" Single Oven
A Cabinet Width 25" (63.5 cm) min. 28½" (72.4 cm) min.
25¼" (64.1 cm) max. 28%" (72.7 cm) max.
B Cutout Height 27%" (70.2 cm) min. 27½" (69.2 cm) min.
28½" (71.4 cm) max. 27%d' (69.4 cm) max.
C Unit Overlap Top 1" (2.5 cm) 1" (2.5 cm)
(1VJ' (5.2 cm) for PT9050)
D Unit Overlap Bottom 1" (2.5 cm) l_/J ' (5.2 cm)
E Unit Overlap Side Edges 1" (2.5 cm) _¼_d'(1.75 cm)
F Junction Box Location 8sA" (22.2 cm) max. 9½" (24.1 cm) max.
right side only right side only
Continue to Section 4.