Connect Water Supply; Reverse Door Swing - GE Monogram ZDIC150 Installation Instructions Manual

Installation Instructions
CONNECT WATER SUPPLY
• The water line should be flushed to clear ang
foreign material before connecting to the icemaker.
• Connect the water line to the water supplg tube
outside of the rear access cover.
Water
Supply
Line
Copper Tubing:
• Use a standard plumbing female connector or union
for 1/4" copper tubing that can be purchased IocallLI.
Nut
(Supplied)
\.
Line to
Icemaker
Coupling
(Not Supplied)
/
Ferrule
(Not Supplied)
/ Nut
/
(Supplied)
GE SmartConnect'" Tubing:
• Insert the molded end of the tubing into the
icemaker connection. Tighten the compression
nut until it is just hand tight.
Tighten one additional turn with a wrench.
Overtightening can cause leaks!
Make sure there are no sharp bends or kinks that
could restrict water flow.
• Slide the icemaker into its permanent location.
• To prevent rattling,
be sure the copper
tubing does not
touch the side wall
or other parts
inside the cabinet.
• Open the shut-off
valve. Check for
leaks. Tighten
ang connections
(including
connections
at the valve)
if necessarLI.
Water Pan
Drain__4" _ 7-5/16"
Wat
5-11/16"
REVERSE THE DOOR SWING
IMPORTANT:
Disconnect power to the icemaker.
Tools Required:
• 1/4" and 5/16" wrench
• Flat puttLI knife
• Phillips screwdriver
Perts Supplied:
• 4 hinge screws
(on some models)
Perts Identificetion: (For Reference Onlg}
Hinge Pin HandleScrew
Q mmmm
5/16" HexHead EndcapScrew
HingeScrew
Remove door handle (black models}:
• Remove the handle.
• Remove the handle screws and lift off handle.
Remove the door (all models}:
• Remove the hinge pin from the top hinge.
• Lift the door off of the bottom hinge. Place the
hinge pin back into the top hinge.
For stainless steel model:
• Remove two screws each from the top and
bottom of the stainless steel door skin.
Remove the door skin and edge protectors from
the door.
Reverse the door endceps (all models):
• Remove the screws and endcaps from the door,
top and bottom.
Place the top endcap onto the bottom of the
opposite side of the door with the long flat side
facing the door front.
Place the bottom endcap onto the top of the
opposite side of the door, with the long flat side
facing the door front.
• Set the door aside.