Water Filter; Understanding The Display - GE OPAL NUGGET Owner's Manual

Getting Started
GE Profile Opal Ice Maker Water Filter
compatible with the Opal product line. Please follow the installation instructions included with your filter.

Understanding the display

Power
The Power button, when pressed, will activate the
machine controls, and begin the ice making process.
When the machine is active and ON, the Power button,
Light
Toggle between the three modes by pressing the light
button until you reach your desired lighting mode.
Clean
The cleaning cycle is initiated by pressing and holding the
Indicator Lights
machine control display the current status of the Opal.
before it can cycle to make ice or clean.
Dispense
Press and hold the dispense button to start dispensing
will still dispense ice by pressing the middle area where
the button is located.
8
located, so that it fits against the tab located towards
the middle of the backside. Push down into place to
ensure the filter is properly assembled into the unit.
NOTE: To remove the water filter, twist the filter toward
you and lift. The filter should be replaced every 3
months.
WiFi
customers can connect to their Opal and control it
from their Android or iPhone. The indicator light on the
Defrost
indicator is blinking, this indicates that you should put the
machine through a cleaning cycle. Press and hold the
Clean button for 3 seconds to start.
Ice Jam
at the same time. This will rotate the auger in the reverse
direction and should break up any ice jammed in the
chute.
WARNING
While initiating this process, please
the rotating auger.
49-9000015 Rev. 0