GE ZVC36L2SS Installation Instructions Manual page 7

Design Information
PRODUCT DIMENSIONS
ZVC42
Dimensions and Specifications (in inches)
Outside Dimensions
39-1/2"
O O
"1
The custom canopg must be sized to fit the insert
sleeve. Construct the canopg with an opening
that is:
38-314'M/x 13-3116"D
The opening must be constructed of 3/4" thick
material to allow the sleeve locking clips to
engage.
The Supplied Liner
40-1/2"
7/8"
The Insert Sleeve
13,_9-112"
1/2'
38-1/2 .....................
21-1/4"
/'
i_ Front side ,,
14"
.... ! /2"
/2" 1/2"
A 1/2" wide flange surrounds the outside edge of
the insert sleeve.
The stainless steel liner is shipped with each hood
insert. This non-combustible liner protects the
underside of the canopy.
Remote Location for the Control
The control may be removed from the hood
and installed into a wall or countertop. A 30-ft.
length of wire is supplied to accommodate most
installations. A blanking plate covers the opening
when the controls are removed.
Custom Liner
If gou are not using the supplied liner, gou mag
construct a custom non-combustible linen Use the
supplied liner as a template. The opening must be
38-314"W x 13-3/16"D. 3/4" thick material must
surround the opening to allow the sleeve locking
clips to engage. The insert sleeve inside the cabinet
should be positioned 1/2" from the rear wall so
that the center of the 8" duct is 5-1/2" from the
rear wall.
The overall size of the control is 4-1/4" wide and
2-I/4"deep.
1-11/16"
3-11/16"
Control cutout
We recommend that the cutout in granite or other
hard surfaces be made before the countertop is
installed.