Table of Contents
Advertisement
Installation
Instructions
STEP 14 CONNECT
POWER SUPPLY
Skip this step if equipped with power cord,
Verify that power is turned off at the source_
, Remove junction
box cover W'
• Locate the three dishwasher wires, twhite, black and green)
[]
with stripped ends Insert dishwasher wires through the small
hale in the junction box "B"
[]
• Secure house wiring to the bottom of the junction
box with o
[]
strain relief "C'
• Use wire nuts to connect incoming ground to green, white to
[]
white and black to black 'D"
[]
• Replacejunction
box cover 'E" Check to be sure that wires
are not pinched under the cover
A
Remove
Junction Box
Cover
D Use UL Listed
Wire Nuts
B Check That White. Block and
Green Dishwasher
Wires Are Threaded
Figure
GG
Thru Hole in Back
i
White
Black
c
""",
Insert Power
//'
Strain Relief
and Tighten
If house wiring is not 2-wire with ground, a
ground must be provided bg the instolte_
When house wiring is aluminum_ be sure to
use UL Listed anti-oxidant
compound
and
aluminum-to-copper
connectors
STEP 15 PRETEST CHECK LIST
Review this Fist after installing
gour dishwasher
to avoid
charges for o service cell that is not covered by gour
warranty,
[]
[]
[]
[]
[]
[]
[]
[]
Check to be sure power is OFF
Open door and remove al! foam and paper packaging
Locate the Owner's Manual in the literature package
Read the Owners
Manual for operating
instructions
Check door opening and closing If door does not open and
close freely or tends to fall. check spring adjustments
See
Step 1
Check to be sure that wiring is secure under the dishwasher.
not pinched or in contact with door springs or other
components. See Step 9
Check door alignment with tub.. If door hits tub. level
dishwasher
See Step 10
Pull lower rack out. about half wag Check to be sure it does
not roll back or forward on the door If the rack moves,
adjust leveling legs See Step 10
Check door alignment with cabinet
If door hits cabinet.
reposition or releveI dishwasher
See Step 10
Verifg water supply and drain lines are not kinked or in
contact with other components Contact with motor or
dishwasher frame could cause noise, SeeStep 8
Turn on the sink hot water faucet and verifg water
temperature.
Incoming water temperature
must
be between t20°F and 150°F A minimum of 120°F
temperature
is required for best wash performance
See
"Prepare Hot Water Line." page 5..
Add 2 quarts of water to the bottom of the dishwasher to
lubricate the pump seal
Turn on water supplg Check for leaks Tighten connections
if needed
[]
Remove protective film if present from the control panel
and door
[]
Avoid service call charges by ensuring there is an air gap
or drain hose routed through the required 32' minimum
height
I1
Advertisement
Table of Contents
