At Pro Control Panel; Quick Start Guide - Garrett AT Pro Owner's Manual

AT Pro CONTROL PANEL

Target ID
Legend
indicates
metal types.
Digital
Target ID
(also shows
High Resolution
ground balance
Iron Discrimination
settings while in
indicates level of iron
GND-BAL mode.)
discrimination selected.
Mode
Indicator
Sensitivity
Setting
Iron Disc
Pushbutton
Iron Audio
Use (+) or (-) to change
iron discrimination
Use to hear
level.
discriminated
iron.
ON / OFF Power:
hold 1 second
to turn power on/off.
MODE:
push quickly to toggle
between detection modes.
RESET:
hold 5 seconds to restore
factory settings.
SENSITIvITy
Pushbutton
increases or decreases sensitivity.
4
Garrett Metal Detectors
Lower Scale
indicates notch
Target ID
discrimination pattern.
Cursor
indicates
probable Coin Depth
target identity.
Indicator
indicates depth of
coin-sized target.
Battery Level
PINPOINT /
Indicator
Frequency
Adjust
GROUND BALANCE
Pushbutton
Pushbutton
Press and hold to
Press and hold for fast auto
pinpoint or use with
ground balance or use with
SENSITIVITY (+)
NOTCH DISC (+) or (-) for
or (-) to change
manual ground balance.
frequency.
ELIM and NOTCH DISC
Pushbuttons
Use NOTCH DISC (+) or (-) to select
a cursor. Then use ELIM button to set
its discrimination on or off.

QUICk START GUIDE

1. Install batteries.
The AT Pro operates with four (4) AA batteries which are
already installed by Garrett.
2. Power ON.
Press and release the ON / OFF Power button. The AT Pro
powers on in the last mode used and is ready to search.
(Factory default mode is Coins.)
3. Select Mode.
Use the Mode Pushbutton to select a different detection
mode, when desired.
4. Adjust settings.
Adjust Sensitivity or Discrimination settings, if desired.
5. Begin scanning.
Lower the searchcoil to 1 to 2 inches above the ground and
scan the coil left and right at approximately 3ft/second.
5
AT Pro™