Advertisement
Toe
PaneU
Figure12
J
Figure 13
Dishwasher Preparation
DISHWASHER
PREPARATmON
(continued}
When any covers are removed or the dishwasher
is out of the cabinet, eJectdcal power and sharp
edges or points may be exposed.
Removing
theToe Pane1
Regular Toe Panel
The toe paneUis UooseUy a ttached with tape, Remove the
tape and pull the toe paneUaway from the dishwasher, Set
the toe paneUaside, Ut w HU be reinstalled Uater,
Plastic Base Access PaneJ and Toe PaneJ (SHY660,
SHX99A, SHE660, SHE990 and SHX570 modeJe only)
The plastic base access panel and toe panel are in place
on the dishwasher, but are not attached, Remove the toe
panel first, as shown in Figure 12, then remove the
plastic base access panel, as shown in Figure 12,
Do not overtighten
the 90 ° elbow. Doing so may
damage the water intet vaJve and cause a water
teak.
installing the 90 ° Elbow Fitting
NOTE: The 90 ° elbow fitting is not supplied with the
dishwasher, and must be purchased separately, If the
dishwasher's hot water supply line is to be copper tubing,
make certain the elbow has a compression fitting,
ApplyTefion tape or other pipe sealant when required,
Orient the hot water supply connection leg of the elbow
toward the channel opening in the dishwasher base, See
Figure 13,
Junction
Box Preparation
1
Remove junction box cover (see Figure 14) by lifting
the junction box cover up and off,
2
Remove the strain relief plate by removing the screw
at the back of the junction box, as shown in Figure
15 and sliding the strain relief plate out,
3
Set the junction box cover, strain relief plate, and
screw aside, They will be re°installed later,
Figure 14
Figure 15
8
Advertisement
