Kenmore 630.1399 Installation Manual page 11

Your dishwasher comes with a three-piece toe panel to
allow height adiustment.
1. Position the slotted rear toe panel (X) on the dishwasher
first. Allow it to rest on the floor.
2. Position the mating front toe panel (Y) on top of the
rear toe panel allowing the angled edge to rest on the
mating edge of the dishwasher.
3. Drive the two black screws (A) (supplied) through the
hole in the toe panel to secure. Only use the supplied
screws to avoid damaging the dishwasher.
Attach water line to incoming hot water shut off valve.
• Turn on water and check for leaks.
• Turn power back on at fuse box.
• Start dishwasher and listen for water and pump for
water distribution. Press Cancel/Reset to drain and
check for leaks.
11