Lan - D-Link DSL-2500U User Manual

DSL-2500U ADSL2/2+ Router
User Manual

LAN

To configure the router's local interface, proceed to the Net / LAN page.
If needed, edit the basic parameters of the local interface.
Parameter
IP Address
Netmask
When needed settings are configured, click the Save button.
In the Static DHCP section, you can specify MAC address and IP address pairs (set a fixed IP
address in the local area network for a device with a certain MAC address). The router assigns IP
addresses in accordance with the specified pairs only when the DHCP server is enabled (in the
DHCP server section, in the Mode drop-down list, the Enable value is selected).
To create a MAC-IP pair, click the Add button and specify the following parameters:
Parameter
IP address
MAC address
When all needed MAC-IP pairs are specified, click the Save button.
Existing MAC-IP pairs are displayed in the table of the Static DHCP section. To remove a pair,
select the relevant line in the table and click the Remove button. Then click the Save button.
Figure 48. The page for configuring the local interface.
The IP address of the router in the local subnet. By default, the
following value is specified: 192.168.1.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
An IP address which will be assigned to the device with the
specified MAC address.
The MAC address of the device from the LAN.
Page 52 of 82
Configuring via Web-based Interface
Description
Description