Kenmore 721.63652 Installation Instructions Manual page 17

STEP 6:
A TTA CH THE 0 VEN TO THE WALL
WARNING
You will need two people to lift this
microwave. Failure to use more
than one person could result in
personal injury.
1. Carefully lift microwave oven and hang it on support
tabs (See Figure 26) at the bottom of the mounting
plate. Reaching through upper cabinet, thread
power supply cord through the power supply cord
hole in the bottom of the upper cabinet.
See Figure 30.
2. Rotate the microwave oven upward so the top of
oven is against the bottom of the upper cabinet or
cabinet frame.
3. Then insert abott down through each hole in the
upper cabinet bottom. See Figure 31.
Tighten the bolts until the gap between the upper
cabinet and microwave oven is closed.
4. If walt vented or room vented installation is used, go
to No. 7 on the next page.
Figure 30
m
Z
t"
m
g_
Z
Figure 31
17