Kenmore 721.80402 Installation Instructions Manual page 16

STEP 5: INSTALL THE MOUNTING
PLATE TO THE WA L L
TO PREPARE THE REAR WALL
CUTOUT OPENING AND EXHAUST
ADAPTOR/MOUNTING PLATE FOR
WALL VENTING AND ROOF VENTING:
NOTE: If room vented installation is used, skip this
step.
1. Place the mounting plate against the rear wall as
described in step 5 item 1 (page 15).
2. Use the wall template to determine the location and
size of the box cutout for the rear wall duct. See
Figure 28.
Attach the exhaust adaptor to the rear mounting
plate by sliding it into the guides at the top center
of the plate on the wall side. Push in securely until
it is past the top locking tabs and in the lower
locking tabs. Take care to assure the damper
hinge is installed so that it is at the top and that the
damper swings freely.
Carefully guide the exhaust adaptor, now attached
to the Back of oven, into the house duct, before
using the screws to attach the plate to the wall.
This will assure proper alignment for installation.
See Figure 29.
Return to step 5, item 3 (page 15) to continue.
After completing the installation of the Back of
oven, again check the rear damper for free
movement to assure it will operate properly.
t
I
REAR WALL TEMPLATE
C ± J
Figure 28
Exhaust Adaptor ._
Slide exhaust
adaptor into
guides on I
rear panel. I
Locking
Tabs
Damper
(hinge side up)
Back of oven
(wall side)
Guides
Figure 29
16