Electrical Requirements; Electrical Safety Instructions - Kenmore 401.8505 Installation Instructions Manual

I SA ETYI
This product requires a three-prong grounded outlet. The
installer must perform a ground continuity check on the power
outlet box before beginning the installation to insure that the
outlet box is properly grounded. If not properly grounded, or
if the outlet box does not meet electrical requirements noted
(under ELECTRICAL REQUIREMENTS), a qualified electrician
should be employed to correct any deficiencies.
CAUTION: For personal
safety, remove house fuse or
open circuit breaker before
beginning instalJation to
avoid severe or fatal shock
injury.
IMPORTANT=PLEASE READ CAREFULLY. FOR PERSONAL
SAFETY, THIS APPLIANCE MUST BEPROPERLY GROUNDED
TO AVOID SEVERE OR FATAL SHOCK.
ground exists
before use
The power cord of this
appliance is equipped with
a three=prong (grounding)
pJugwhich mates with
a standard three-prong
(grounding) wall receptacle
to minimize the possibility of
electric shock hazard from
this appJiance.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz,
. 85052, 85053, 85059:14.5 arnps and 1.7 kilowatts.
This product must be connected to a supply circuit of the
proper voltage and frequency. Wire size must conform to the
requirements of the National Electrical Code or the prevailing
local code for this kilowatt rating. The power supply cord
and plug should be brought to a separate 20 ampere branch
circuit single grounded outlet. The outlet box should be
located in the cabinet above the microwave oven. The outlet
box and supply circuit should be installed by a qualified
electrician and conform to the National Electrical Code or
the prevailing local code.
ELECTRICAL SAFETY
iNSTRUCTiONS
CAUTION: For personal safety, the mounting surface must
be capable of supporting the cabinet load, in addition to the
added weight of this 59 pound product, plus additional oven
loads of up to 50 pounds or a total weight of 109 pounds.
CAUTION: For personal safety, this product cannot be
installed in cabinet arrangements such as an island or a
peninsula, it must be mounted to BOTH a top cabinet AND
a waft.
NOTE: For easier installation and personal safety, it is
recommendedthat two peopJeinstalJthisproduct.
You should have the wall receptacle and circuit checked
by a qualified electrician to make sure the receptacJe is
properJy grounded.
Where a standard two=prong wall receptacle is encountered,
it is very important to have it repJaced with a properJy
grounded three=prong waft receptacJe, instalJed by a
qualified eJectrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM
OR REMOVE ANY OF THE PRONGS FROM THE POWER
CORD. DO NOT USE WiTH AN EXTENSION CORD.
8505 XAA 03807A-EN+MES.indb 3 2010-07-08 6:52:50