Recirculating (Non-Vented Ductless) - Kenmore 401.8505 Installation Instructions Manual

A. RECIRCULATING (NON-VENTED DUCTLESS)
iNSTALLATiON OVERVIEW
A1. Attach mounting plate to wall
A2. Prepare top cabinet
A3. Mount the microwave oven
Attach the plate to the wall using toggle bolts. At least one
wood screw must be used to attach the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the hales
designated to go into drywall and reattach the toggle wings
to 3¼- onto each bolt.
To use toggle barfs:
Spacing for Toggles More Than Wall
._ ___,._kness
i
i Toggle Wings
Mounting
Plate
,O
3. Place the mounting plate against the wall and insert the
toggle wings into the holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure to line up bottom line of the Mounting plate
with Horizontal line of "Rear wall Template" and then the
Mounting plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the
back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to help
tighten the bolts.
A2. Use top cabinet template for
preparation of top cabinet
You need to drill holes for the top support screws and a hole
large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the
cabinet bottom.
12
8505 XAA 03807A-EN+MES.Jndb 12 2010-07-08 6:53:01